relic hunting with the 4000

Hi everyone!
Going to a relatives property at a site which was occupied by australian and american troops during world war 2 and later was a main port supplying Rockhampton by boat. has anyone got some tips on settings to run the 4000 relic and coin hunting?
Discrimination etc? Or would it be best to use all metal?
As it is a coastal site should i use the salt setting?
Cheers,
Jason

i think i know the area you are detecting.

i'd be running the minelab 11" DD coil with desc of 5.

you won't need salt mode. general should be fine.

Hi Goltzy, presumably your looking for all metal relics so I would say just run it as per normal Mono or DD unless you get into some serious salt areas then try salt.
Regards
Wayne.

hi all, I was swinging over some shafts last wend and picked up a threepence at mabie 5 inchs with a 11inch dd in basic settings for the 4000, if anyone knows about coin value it whould be good to hear from ya! its 1881? cheers!

joe82 wrote: hi all, I was swinging over some shafts last wend and picked up a threepence at mabie 5 inchs  with a 11inch dd in basic settings for the 4000, if anyone knows about coin value it whould be good to hear from ya! its 1881? cheers!

Hey Joe
If you have questions on coins, go see QLD Sandy, Peter Cragg at Gold City Detecting.

cheers!