fibreglass upper shaft for gpx4000

hi all,i am looking for a fibreglass upper shaft for a minelab 4000 that will fit the std lower,does anybody know where i could locate one,my enquiries have only located the otto which wont fit the std minelab lower apparently.

Gday Kiwi

Some of my standard minelab shafts will fit into the otto top shaft, might be from the older machines like the sd2100, and if they are a bit worn in helps, a couple are a bit tight and wont push all the way in , but will go in far enough to lock the pin in the first couple of holes .

Give it at try and see how you go.

cheers


stayyerAU

Use some sandpaper on the lower ML shafts. That fixes the problem, and you can then use them with to Otto top shaft

thanks for for info,i will give it a go cheers kiwi.

HI ALL OF MY SHAFTS, MINELAB AND AFTERMARKET FIT THE OTTO UPPER SHAFT.
CHEERS FENCEJUMPER

ditto to above --- all my lower shafts fit the otto top shaft, no problems ... kev